Technics KN7000 · Setup and careJump straight to a setting by holding its button

From the manual Not yet tested on a KN7000.Also called: press and hold, hold a button, shortcut, shortcuts, Easy Setting, quick settings, settings screen, hold for settings.

Holding a button

Holding some panel buttons for a few seconds opens a settings screen directly, without going through the menus. The Reference Guide calls these Easy Settings. Source: Reference Guide, p. 3

The Reference Guide’s page shows eleven buttons. The owner’s manual describes four more, among them MIC and SPLIT POINT. Source: Manual, pp. 27, 40, 45, 65, 140

Most of these screens are also in the menus. Source: Reference Guide, pp. 2–3 See Find which menu holds a setting.

The buttons

The buttons fall into four groups: effects, playing and styles, panel memories, and loading. Some examples follow. The Reference Guide’s eleven are on its page 3. Source: Reference Guide, p. 3

Effects

Each effect button opens the settings for its own effect. For example, REVERB opens the reverb type and its depth, and SOUND DSP opens the effect type and depth for one part. Source: Manual, pp. 43–45 See Pick an effect type for a sound.

Playing and styles

For example, FADE IN or FADE OUT opens the fade times, and whether the style or the sequencer stops when a fade-out ends. Source: Manual, p. 59

SPLIT POINT works differently: hold it, then press a key to put the split point there. The split point is the lowest key of the right-hand section. Source: Manual, p. 40 See Split the keyboard and layer Right 1, Right 2 and Left.

Panel memories

A panel memory stores a whole panel set-up for recall at one press. Source: Manual, pp. 22, 65 See Store your set-up in a panel memory.

For example, SET opens PANEL MEMORY MODE, which chooses what a panel memory recalls. Source: Manual, pp. 22, 67

Loading

For example, DISK and SD open the LOAD screen, for a floppy and for an SD card. Source: Manual, pp. 27, 125, 140 See Load a save from a card or floppy.

ONE TOUCH PLAY also works by holding, but it sets up the panel for the chosen style rather than opening a screen. See Set the sounds and tempo for a style (One Touch Play). Source: Manual, p. 61

Keeping the screen on show

Some of these screens close by themselves a few seconds after the last change. Source: Manual, pp. 59, 65, 67

The time these screens stay up can be set:

  1. Press CUSTOMIZE to turn it on. The screen shows CUSTOMIZE MENU.
  2. Choose DISPLAY TIME OUT.
  3. With the DISPLAY TYPE ∧ and ∨ buttons, choose EASY SETTING.
  4. With the TIME ∧ and ∨ buttons, choose DEFAULT (the factory time), 1 to 10 seconds, or HOLD.
  5. Press OK.

Source: Manual, pp. 181, 183

With HOLD, DISPLAY HOLD turns on by itself when the screen opens. Source: Manual, p. 183

Manual pages

KN7000 Reference Guide, p. 3.

Corrections: hello@knarrangers.com

All KN7000 guides

Guide H15 · last checked 18 Nov 2026