Troubleshooting · KN7000The floppy drive says "no disk" or won't read

Checks in order when the KN7000's floppy drive shows error 02, won't read a disk or asks to format it.

Written for: KN7000.Also called: no disk, Error 02, 002, C002, floppy not reading, floppy won't read, disk not recognised, floppy drive dead, floppy error, read error, wants to format, DISK FORMAT, 2DD, 2HD, DD, HD, 720 KB, 1.44 MB, floppy light always on, drive noise, floppy emulator, USB floppy drive, copy floppies to computer.

The KN7000 reads 3.5-inch floppy disks of two kinds: 2DD (double density, 720 KB) and 2HD (high density, 1.44 MB). Source: Manual, p. 122 Error 02 means the keyboard finds no disk in the drive. Source: Manual, p. 203 One owner saw it shown as 002 or C002. Source: Community report, 2021

Normal, not a fault

  • The light on the drive itself stays on whenever the keyboard is switched on. The DISK IN USE light, beside the DISK button, is the one that shows the drive at work. Source: Manual, p. 124
  • The drive makes a noise while it reads. Source: Manual, p. 202

The settings

When a disk goes in while the main screen shows, the DISK MENU appears. If it doesn’t, press DISK. Source: Manual, p. 124 PREFERENCES, on the DISK MENU, sets which screen appears when a disk goes in. Source: Manual, p. 124

The disk

  1. A 2HD disk formatted as 2DD can’t be used. Source: Manual, p. 122 A KN2000 formats 2HD disks as 720 KB. One owner’s KN7000 refused such disks until the second square hole, opposite the write-protect tab (the small slider in one corner), was taped over. Source: Community report, 2007
  2. A disk that hasn’t been formatted brings up the DISK FORMAT screen when you try to load or save. Formatting erases the disk. NO cancels. Source: Manual, p. 130 If the disk holds anything you need, copy it on a computer first (below).
  3. Owners found disks formatted on Windows 10 or 11 unreliable in the keyboard, and format their disks in the keyboard instead. Source: Community report, 2015–2026 The steps are in Save your work to a card or floppy.
  4. Floppies decay. An unused commercial disk of styles, the accompaniment patterns, gave a read error in 2014. Owners give a disk 5 to 10 years; some say less. Source: 3 community reports, 2014–2025
  5. A torn disk label jammed one drive. Once it was taken out, the drive read again. Look into the slot with a torch. Source: Community report, 2017

Then check, in order:

  1. Try a disk formatted in this KN7000.
  2. Try a disk known to read in another keyboard or computer.
  3. Listen for the drive spinning when a disk goes in.

Source: Community report, 2007–2022

Older models’ drives take different disks. The KN800, KN1000 and KN2000 take 2DD disks only. Source: Community report, 2010–2015

Copy old disks while they still read

The SD card saves and loads the same data as the floppy drive, so it can take over everyday saving. Source: Manual, p. 138 COPY FROM DISK, in SD TOOLS, copies up to 20 saves from a floppy into a card folder in one go. Source: Manual, p. 151 See Files copied from a computer don’t show on the card.

The drive itself

  • One KN7000’s drive made no sound, and it still showed “no disk” with two other drives fitted in its place. The fault was thought to be on the board that runs the drive. It wasn’t resolved. Source: Community report, 2021
  • Owners have fitted USB floppy emulators, which take the drive’s place and read disk images from a USB stick, in KN7000s, but no tested set-up for the KN7000 has been published. Source: 4 community reports, 2019–2024 Fitting one means opening the keyboard: see the note below. Source: Inferred

When to call a repairer

When a disk formatted in this KN7000 fails too, or the drive makes no sound with a disk in. The drive, or the board that runs it, is a repairer’s job. Source: Community report, 2007–2022

Corrections and owners' experience: hello@knarrangers.com

All troubleshooting pages · FAQ

Last checked 15 Nov 2026